Product Details
2 IR Beams Infrared Barrier
ALEAN active infrared barriers, when one or more beams are interrupted, the system triggers an alarm signal to alarm control panel,the detection range can reach 100m. to meet all of your specialised needs, we have developed different height from 48cm to 204cm that can be used with all of our products.
Introduction :
NC/NO relay output
High quality aluminum alloys cover
Easy alignment with visual LED indicator and audible buzzer
CPU microprocessor, good performance against outdoor interference
Horizontal optical angle can be easy to adjust (180°)
Multiple Interactive infrared beams shooting. Adjacently 2 beams interruption detection
Digital frequency conversion
AGC pure digital circuit design, DSP digital chip programming, reduce false alarm
Resistant to rain, fog, snow and frost
Product Parameter
Power supply: DC 9-30V
Current consumption: 50-120mA
Temperature: -30℃-+70℃
Alarm output: NO/NC optional (factory default NC), contact capacity 30V 2A
Detection method: block two adjacent beams (single beam alarm can be set)
Alarm duration: ≥1S (instant alarm can be set)
Independent tamper output: when the shell is removed, NC output
Response speed: ≤40ms
Optical axis adjustment angle: horizontal 180°, vertical is non-adjustable
Other additional functions: LED indication, buzzer prompt
Material: aluminum, PC engineering plastics
Product Feature And Application
Production Details
ALEAN 2 IR beams infrared barrier adopt the electrophoresis treatment process on the surface aluminum tube body ,it make the surface of the pipe body is harder and not easy to produce scratches,highly waterproof and effectively responds to bad weather.The barrier has two different frequency channels, avoiding interference caused by adjacent rays.The alarm method is any two adjacent beams breaks will give out an alarm, helpful for preventing false alarms triggered by small animals and birds.
Product Qualification
FAQ
1.Fault :The buzzer sounds shortly
Analysis:
1. A single beam light is not align right
2. Whether the lens holder installed on the PCB board is loose or damaged, and the launch tube is abnormal
3. You can jump the buzzer control jumper J4 to the DOU side
2.Fault:Transmitter and receiver alignment LED are always on and the buzzer beeps for a long time
Analysis:
1. The transmitter and receiver can be selected as frequency A or frequency B at the same time (J1 is plugged in or not)
2. Check whether the power supply of the receiver machine is normal; whether the synchronization line is in good contact in J2 unplugged synchronization mode.
3. Re-plug the debugging jumper J3 of the tamper switch; re-plug the power adjustment jumper
4. Whether there are obstructions between the transmitter and receiver; whether it exceeds the guard distance of the barrier and whether the power is too small
5. Whether the lens holder installed on the PCB board is loose or damaged.
http://www.aleansecurity.com/
Company Profile
